This module allows you to automatically pause the 3D print job if the filament breaks or runs out. This allows you to insert new filament and resume the print job.
The filament passes through the module and triggers a switch, causing the LEDs on the module to go off.When there is no filament, the switch lowers and the LEDs on the module signal that no filament has been detected.
It works with all mainboards with an interface for filament detection among others: BTT SKR MINI E3, SKR E3 DIP, SKR 1.3, SKR 1.4 MKS GenL, MKS Gen 1.4 ect.
The module is also compatible with various displays such as the 2004, 12864, Bigtreetech TFT24 & TFT3.5. Support for MKS TFTs and other touch displays will follow.
Operating voltage: 3.3V - 5V
Filament diameter: 1.75mm
Recommended firmware: Marlin 2.0.x
Bristle length: 15mm
Handle material: plastic
Bristle material: brass
Advantages and features of this product:
Sturdy hand wire brush
Studded with crimped brass bristles
Ideal for 3D printer nozzle cleaning
Removes filament residue from the printer nozzle
Bristles are easily shortened with scissors
Total length 190 mm (19cm)
Bristle length 15mm (1,5cm)