Mechanik
Items 21 - 30 of 30
In stock
Threaded nut as spare part for Creality CR-10/CR-10S/CR-10S Pro 3D printer.
In stock
POM (Polyoxymethylene) is a good high molecular weight thermoplastic. POM nuts are used in 3D printers and convince through wear resistance.
In stock
Timing belt clamp for GT2 belts up to 9mm width
Vibration dampers for Nema17 stepper motors. With these dampers, the motor vibrations of the Nema17 motors can be reduced. To avoid skewing of the stepper after tensioning the GT2 belts, we recommend two dampers per motor for X and Y axis.
Features:
- Two steel mounts with vibration dampening rubber layer.
- Designed for Nema17 motors
- Virtually torsion free with no loss of damping
- Torsionally stiff
*Note: This item is shipped in bulk (like screws in a box). It may well be that the surfaces are scratched, but this does not affect the function.
You want to show off your conversion? No problem. Just send us a message and we will publish your construction in our blog and on Facebook. Show what you can do
In stock
Trapezoidal thread nut TR 8 8mm pitch Backlash-free bolt circle for Creality threaded nut as a spare part for Creality CR-10/CR-10S/CR-10S Pro 3D printer.
Slide Y right, length 83mm, width 42mm, height 62mm, For 8mm shafts, weight oriented manufacturing.
In stock
Carriage Y left, length 83mm, width 18mm, height 62mm, For 8mm shafts, weight oriented manufacturing.
Plastic arm (stiffener, struts) for Makerbot, CTC, Wanhao, FlashForge and other similar 3D printers. We have already successfully installed this spare part on the printers mentioned below. The arms of the Z-axis are made of ABS and should be replaced over time.
In stock
Material: Aluminum, Length: 25mm, Outer diameter: 14mm, Input shaft diameter: 5mm, Output shaft diameter: 8mm, Weight: 16g
Best sellers
Material: Aluminum, Length: 25mm, Outer diameter: 18mm, Input shaft diameter: 5mm, Output shaft diameter: 8mm, Weight: 16g
Items 21 - 30 of 30