None
Items 71 - 80 of 203
In stock
Including heating block and throat (full metal verion). Thread M6, Extra long melt zone, For higher printing speeds and greater outflow, Filament suitability 1.75 mm.
In stock
Retaining clips for the backward locking of the glass plate with a clamping range of 5mm on the Ultimaker Original. Ultimaker Original Plus, Ultimaker 2, Ultimaker 2+, Ultimaker 2 extended, Ultimaker 3, Ultimaker S5 and many more printers.
In stock
- Prevents frequent leveling of the 3D printer. Very high stiffness!
- Highest quality! Anodized surface: Prevents scratches and oxidizing fingerprints. Deburred edges: This manufacturing step is often omitted by other manufacturers.
- Suitable for Ultimaker 2, 2+ or own designs.
- Stiffness optimized construction 610g from 4mm aluminum alloy.
- High quality workmanship with German quality assurance
- Highest quality! Anodized surface: Prevents scratches and oxidizing fingerprints. Deburred edges: This manufacturing step is often omitted by other manufacturers.
- Suitable for Ultimaker 2, 2+ or own designs.
- Stiffness optimized construction 610g from 4mm aluminum alloy.
- High quality workmanship with German quality assurance
In stock
M3 knurled nut for easy mounting and leveling of heating beds and printing plates. Suitable for Ultimaker Original, Ultimaker 2, Ultimaker 2+ and the corresponding Extended versions. Height: 12mm, head diameter: 15mm
In stock
Model DaVulcan Hot End Heater Block - Compatible with many printers - Easy to use - Only suitable for Vulcan Nozzle - Filament diameter depends on Nozzle
In stock
This VolcanoV2 heater block allows you to use the high temperature PT100 sensors with high accuracy on your Volcano, making it compatible with the PT100 upgrade kit on your V6 hot end.
In stock
- Model DaHotend CR-10, Cr-10s, CR-10 S4, CR-10 S5, Ender and similar 3d printers
- More compact design
- Improved temperature control and cooling
- Nozzle diameter 0.4 mm
- Filament suitability 1.75 mm
- More compact design
- Improved temperature control and cooling
- Nozzle diameter 0.4 mm
- Filament suitability 1.75 mm
In stock
Idler idlers for 6mm wide GT2 timing belts. With ball bearings for quiet and vibration-free operation. Suitable for 3mm axles or M3 screws. Features:
⢠Aluminum
⢠Toothless
⢠3mm axle diameter
⢠Aluminum
⢠Toothless
⢠3mm axle diameter
In stock
This sturdy corner angle made of steel connects three aluminum profiles at the same time at a right angle to each other. The aluminum profiles should have a cross-section of 20 mm x 20 mm and a groove opening of 6 mm.
Top rated
Inner diameter 6 mm, outer diameter 12 mm, length 30 mm, quiet running, LM6LUU
Items 71 - 80 of 203