None
Items 1 - 20 of 214
In stock
Single row ball bearings with deep raceway grooves - Narrow osculation between raceway grooves and balls - Radial and axial loads in both directions, even at high speeds
In stock
Height: 6mm - Width: 10mm - Hole: 5mm
In stock
Height: 6mm - Hole: 5mm - Adjustment width: 0.1-0.5mm - Material: Stainless steel
In stock
Ribbon cable : AWG28 RM1,27 8pin - Post sockets: 8pin, RM2,54 - Length : 60cm
In stock
Retaining clips for the backward locking of the glass plate with a clamping range of 5mm on the Ultimaker Original. Ultimaker Original Plus, Ultimaker 2, Ultimaker 2+, Ultimaker 2 extended, Ultimaker 3, Ultimaker S5 and many more printers.
In stock
M3 knurled nut for easy mounting and leveling of heating beds and printing plates. Suitable for Ultimaker Original, Ultimaker 2, Ultimaker 2+ and the corresponding Extended versions. Height: 12mm, head diameter: 15mm
Best sellers
Amperage: 3A-5A
Voltage: 125V-250V
Voltage: 125V-250V
Best sellers
Amperage: 3A-5A
Voltage: 125V-250V
Voltage: 125V-250V
In stock
Current: 5A
Voltage: 250V
Voltage: 250V
Best sellers
This 100cm cable is perfect for connecting stepper motors in 3D printers, CNC mills and robots. The cable has a 6pin JST PH2.0 and a 4pin JST XH2.54 connector.
Best sellers
This 150cm long cable is perfect for connecting stepper motors in 3D printers, CNC mills and robots. The cable has a 6pin JST PH2.0 and a 4pin JST XH2.54 connector.
Best sellers
This 20cm cable is perfect for connecting stepper motors in 3D printers, CNC mills and robots. The cable has a 6pin JST PH2.0 and a 4pin JST XH2.54 connector.
In stock
Material: Stainless steel 1.4301 / 1.4305 - Profile size: 20 - Groove width in mm: 6 - Profile compatibility: TypeB - Thread: M3
In stock
Material: Stainless steel 1.4301 / 1.4305 - />Profile size: 20 - Groove width in mm: 6 - Profile compatibility: TypeB - Thread: M4
In stock
Material: Stainless steel 1.4301 / 1.4305 - Profile size: 20 - Groove width in mm: 6 - >Profile compatibility: TypeB - Thread: M5
Straight screw-in connectors 4mm Bowden Tubes for clipping to the hotend. The plastic PushFit connectors of the brand Advanc3D are optimized for the application in 3D printing.
In stock
PushFit, 6mm tube connector, plastic, for Ultimaker
In stock
These socks keep your nozzle clean and do not burn on shrunken plastic. They not only keep the nozzle clean, but also keep the heat in the hot end and away from the print.
In stock
These socks keep your nozzle clean and do not burn on shrunken plastic. They not only keep the nozzle clean, but also keep the heat in the hot end and away from the print.
In stock
These socks keep your nozzle clean and do not burn on shrunken plastic. They not only keep the nozzle clean, but also keep the heat in the hot end and away from the print.
Items 1 - 20 of 214