Advanc3D
Items 1 - 10 of 22
Best sellers
V6 style nozzle for 3D printers, type - V6 style, filament diameter - 1.75mm, nozzle type - direct, nozzle length - 13.2mm, key width - 7mm, nozzle thread - M6, nozzle thread length - 7.9mm
Best sellers
Model: J-Head Hot End V5 - Nozzle: 0.4 mm - Filament: 1.75 mm - 12V/24V 40W cartridge heater depending on variation - NTC Thermistor 100k - Connector JST-2.54!
Best sellers
The LM8UU linear ball bearing is an essential accessory for any 3D printer, allowing precise and smooth movement of the moving components. These linear bearings are specifically designed for the 8mm linear shaft and offer optimal performance with minimal maintenance.
Best sellers
Idler idlers for 6mm wide GT2 timing belts. With ball bearings for quiet and vibration-free operation. Suitable for 5mm axles or M5 screws.
Best sellers
Idler idlers for 6mm wide GT2 timing belts. With ball bearings for quiet and vibration-free operation. Suitable for 3mm axles or M3 screws.
In stock
Length: 190mm
Bristle length: 15mm
Handle material: plastic
Bristle material: brass
Bristle length: 15mm
Handle material: plastic
Bristle material: brass
Advantages and features of this product:
Sturdy hand wire brush
Studded with crimped brass bristles
Ideal for 3D printer nozzle cleaning
Removes filament residue from the printer nozzle
Bristles are easily shortened with scissors
Total length 190 mm (19cm)
Bristle length 15mm (1,5cm)
Best sellers
These socks keep your nozzle clean and do not burn on shrunken plastic. They not only keep the nozzle clean, but also keep the heat in the hot end and away from the print.
Best sellers
PushFit, R1/8 thread, 4mm hose connection, cannulated, steel, operating pressure -0,95 to 6 bar, for Hotends
Best sellers
PushFit, 6mm tube connector, plastic, for Ultimaker
Best sellers
PushFit, M6 thread, 4mm hose connection, cannulated, steel, operating pressure -0.95 to 6 bar, for extruder
Items 1 - 10 of 22